Product Description
Producing reliable power from 27.0 to 60.0 ekW at 60 Hz, our C3.3 diesel generator sets designed to ISO 8528-5 transient response requirements. All C3.3 generator sets are R96/EUIIIa equivalent emissions compliant.
Generator Set Specifications
- Maximum Rating
- 60.0 ekW
- Minimum Rating
- 27.0 ekW
- Emissions/Fuel Strategy
- EU Stage II & R96/EUIIIa
- Voltage
- 110 to 480 Volts
- Frequency
- 60 Hz
- Speed
- 1800 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- Cat® C3.3
- Bore
- 4.1in
- Stroke
- 5in
- Displacement
- 201.4in³
- Compression Ratio
- 17.25:1, 19.25:1
- Aspiration
- Turbocharged
- Fuel System
- Direct Injection
- Governor Type
- Mechanical
Generator Set Dimensions
- Length - Maximum
- 43.9in
- Width - Maximum
- 38.2in
- Height - Maximum
- 53.6in
Standard Equipment
-
- Air Inlet System
-
- Air cleaner; light duty with disposable element
-
- Control Panel
-
- GCCP 1.3
-
- Cooling System
-
- Coolant drain line with valve
- Caterpillar extended life coolant
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
-
- Exhaust System
-
- Stub pipe, gaskets, raincap & SAE exhaust flange for customer use - shipped loose
-
- Fuel System
-
- Standard open set fuel tank/base supplied
- Base, formed steel with single wall integral 8-hour fuel tank
-
- Generators And Generator Attachments
-
- Circuit breaker, IEC, 3 pole, mounted in tower panel
- IP23 Protection
- Tower panel, IP22, bottom cable entry
- 12 Leads
- Voltage regulator (single phase sensing)
- Segregated low voltage (AC/DC) wiring panel
-
- Governing System
-
- Mechanical governing system - model dependant
- Mechanical and electrical governing system - model dependant
-
- Lube System
-
- Lubricating oil
- Oil drain line with valve
-
- Mounting System
-
- includes lifting provisions and termination points for coolant
- Includes lifting provision and drag points
- Termination points for coolant and lube oil drain lines
- Captive linear vibration isolators between base and engine-generator
-
- Starting / Charging System
-
- 12V Battery with rack & cables
-
- General
-
- Engine and alternator pre-paint, Caterpillar yellow
Optional Equipment
-
- Alternator System
-
- LC Frame alternator
- Anti-condensation heater
- Permanent magnet excitation (PMG)
- LC Frame alternator with coastal protection
- R Frame auxilliary winding
-
- Alternator
-
- Alternator removal options
-
- Circuit Breakers
-
- 4 Pole Circuit breaker to 250A
- Padlockable breaker device
-
- Control Panels
-
- GCCP 1.3
-
- Control Panel Options
-
- Overload shutdown via breaker
- Volt free contacts
- Earth leakage (2 wire only)
- Speed adjust potentiometer
- Voltage adjust potentiometer
- Battery charger
- Control panel heater
- Earth fault (2 wire only)
- Panel mounted audible alarm
- Emergency stop with key
-
- Cooling System
-
- Coolant heater
- Low coolant level shutdown
- Low coolant temperature alarm
-
- Certifications
-
- European upgrade to STD set for "CE"
- Global certification for CIS
-
- Enclosures
-
- CEE for sockets for enclosure
- Socket blanking plate
- Sound attenuated level 1 enclosure (GALV)
- Sound attenuated level 2 enclosure CE
- Rental pack (CAE only)
-
- Fuel System
-
- Skidbase for CALG enclosure sets
- Low fuel level shutdown
- High fuel level alarm
- Compact skidbase for open sets
- Low fuel level alarm
- Bunded fuel tank
- Open set narrow tankbase
-
- Mounting Options
-
- Silencer installation kit
- Battery removal
- Electronic governor
- Residential silencer
- External single point lift - enclosure
-
- Special Packing Inspections
-
- PGS Test report @ 0.8 power factor
- PGS Test report @ 1.0 power factor
-
- General
-
- Stone guards/rad trans flange
- Packing case - compact set
- Packing case - canopied set